Log Off the iSCB
Log off the iSCB:
[r0s0i0 root]#
exit
logout
Connection to r0s0i0 closed.
[r0s0i0 root]#
IP Address
When
iscb
starts up, the value of the
SCB IP Source
configured in NVRAM is used obtain the IP address:
either
static
or
dhcp
. Switch IDSW3-8 on the SR10216 front panel defines the IP address type: static or DHCP.
Static IP. If the IDSW3-8 switch is set to On/1, the IP address used by
iscb
is based on this scheme:
192.168.XX.YZ
XX: Cabinet ID
Y: iSCB ID (1=iSCB0, 2=iSCB1)
Z: Subrack ID
A non-functional or absent IDSW results in a default IP address setting of 10.11.1.10.
DHCP IP. If the IDSW3-8 switch is set to Off/0, the IP address used by
iscb
is based on addresses defined in
the
dhcpd.conf/dhcpd.hss
and
/etc/hosts
files.
/etc/hosts
192.168.2.10 r0s0i0 rx0y0s0i0 iscb_r0s0i0
192.168.2.11 r0s1i0 rx0y0s1i0 iscb_r0s1i0
192.168.2.12 r0s2i0 rx0y0s2i0 iscb_r0s2i0
192.168.2.13 r0s3i0 rx0y0s3i0 iscb_r0s3i0
iSCB Password
iSCB password. There is no default iSCB password. An administrator should provide one by running the
set
passwd
command while logged in to the iSCB. The new password is NOT stored on the iSCB itself, but instead
saved in NVRAM in the subrack's I/O module. The new password can be applied permanently by running the
nvram save
command.
To reset a forgotten iSCB password:
1. Set the iSCB module to Debug Mode by setting SW4-1 On (1000).
2. Log on to
iscb
without a password.
3. Run the
set passwd
command to define a password.
4. Run the
nvram save
command to save the password to NVRAM.
5. Reset the iSCB module to Normal Mode by setting SW4-1 Off (0000).
6. Run the
reboot
command to apply the new password.
System Monitoring
S3016
105
