Conrad Electronic FAZ 3000-PIR-2, Operating Instructions Manual

Page: 88 / 115

88
3. Setting the duration for the external flash
The duration for the external flash (controlled via the ‘FAZ-SI’) is factory set to 20 minutes, however,
you can adjust this to a time between 1 and 100 minutes.
To set the duration for the external flash, proceed as follows:
• You must be on the main level. The LCD should appear as on the right,
for example, with the time and the date.
• Briefly press the ‘ Menü a/A ’ button on the control unit of the ‘FAZ 3000-
Z’ alarm base station.
• Use the ‘ ’ and ‘ ’ buttons to select the ‘
ext. siren ext. siren ext. siren ext. siren ext. siren
’ menu (‘external
siren’). See the figure on the right.
• Confirm your selection by briefly pressing the ‘ OK ’ button.
• Use the ‘ ’ and ‘ ’ buttons to select the ‘
dur. flash dur. flash dur. flash dur. flash dur. flash
’ menu (‘duration
for the flash’).
• Confirm your selection by briefly pressing the ‘ OK ’ button.
The duration that is currently set appears on the LCD (factory set to 60
seconds).
• Use the ‘ ’ and ‘ ’ buttons to select the required duration. You can set
this to a value between 1 and 100 minutes in increments of 1 minute.
To make a quick setting, keep the ‘ ’ or ‘ ’ button pressed for a few
seconds.
• Pressing the ‘ OK ’ button applies the setting.
• Exit the menu by pressing the ‘ C ’ button twice. This returns you to the
normal display mode (main level).
ext. siren
troubles
disarm
21:57 08.02
ext. siren
trigger
ext. siren
dur. flash
dur. flash
60 min.
dur. flash
20 min.
ext. Sirene
dur. flash
disarm
22:10 08.02