Conrad Electronic FAZ 3000-PIR-2, Operating Instructions Manual

Page: 28 / 115

28
5. Initial operation of the alarm base station
• Press and hold the ‘ 8 tuv ’ button, then connect the power supply to a socket (230V~/50Hz).
Then release the ‘ 8 tuv ’ button.

This procedure resets the alarm base station’s internal memory; all sensors and
peripheral devices are deleted. The alarm base station is then in a defined initial state.
If, at a later point in time, you need to reset the alarm base station to the delivery state
(for example, if you first tested the components of the wireless alarm system next
to each other on a table and you now wish to carry out the ‘real’ installation), proceed
as follows:
Disconnect the power supply from the supply voltage
Open the alarm base station (deactivate the sabotage alarm using the ‘unscharf’
(disarm) button)
Remove the batteries and wait a few seconds
Insert the batteries again, observing the correct polarity
Close the casing of the alarm base station
Press and hold the ‘
8 tuv ’ button
Plug the power supply into the socket again
Release the ‘
8 tuv ’ button
• The alarm base station emits a short signal tone, the LEDs then light up and the LCD is tested.
First of all, the software version of the alarm base station’s installed
operating system appears on the LCD, for example ‘
V1.3 V1.3
V1.3 V1.3
V1.3
’.
Afterwards, ‘
— Init — — Init — — Init — — Init — — Init —
’ appears briefly on the display, indicating
that the alarm base station has been reset.
• Subsequently, ‘
Sprache deutsch Sprache deutsch
Sprache deutsch Sprache deutsch Sprache deutsch
’ (‘language German’) appears
on the display. Here, you can select the language for the command
menu (‘deutsch’ (German) and ‘english’ (English) are possible).

Please note that in the user manual it is assumed that the
language for the command menu is set to ‘
english english english english english
’.
You can select the language for the command menu using the ‘ ’ and
‘ ’ buttons.
Confirm the selection using the ‘ OK ’ button.
• The LCD’s display should now switch to ‘
disarm disarm disarm disarm disarm
’ and the time and
date are displayed on the lower line.
The colon between the hours and minutes blinks.
• The alarm base station is now ready.
V1.3
-- Init --
Sprache
deutsch
disarm
0:01 1.01