52
5. Registering the remote control
The remote control must be registered during the last stage of the complete set’s programming.
Up to four remote controls with different security codes can be registered with the
‘FAZ 3000-Z’ alarm base station. If you require further remote controls, then you have
to set them with one of the already available security codes. This allows you to use
as many remote controls as you require.
Please carry out the following steps:
• Prepare the alarm base station as described on page 47. The LCD appears
as shown on the right.
The same display appears, if you have already registered another sensor
(for example, the door/window detector or the PIR motion detector from
the complete set) and you have not yet exited the registration mode (by
pressing the
‘
C
’ button three times).
Here, ‘
X
X
X
X
X
’ in the upper right figure is the number of already
registered sensors plus one, in other words, the next available
memory slot.
• You select the remote control using the ‘ ’ button. The display shows
‘
rem.con. 1
rem.con. 1
rem.con. 1
rem.con. 1
rem.con. 1
’ on the upper line.
• Briefly press any button on the remote control. The alarm base station
acknowledges reception by emitting a short signal tone and the LCD on
the alarm base station switches to the display for entering the name of
the remote control.
• Use the buttons on the alarm base station to enter the name of the remote
control, such as the name of the person who is using the remote control.
To enter the letters use the 2-9 buttons, each of which represents
several letters (click through as with a mobile phone by repeatedly
and quickly pressing the same button).
Numbers and umlauts can also be found on the buttons (for instance,
‘Ä’).
Use the ‘
0
’ button to enter a space character.
Special characters can be entered using the ‘ ’ and ‘ ’ buttons.
You can use the ‘
Menü a/A
’ button to switch between lower and
upper case.
The cursor automatically jumps to the next position approx. one
second after the last button was pressed.
You can use the ‘
C
’ button to delete a character you entered by
mistake.
• Once you have entered the name you require, press the ‘
OK
’ button.
rem.con. 1
clear
rem.con. 1
_
rem.con. 1
Peter_
sensor X
clear
Summary of Contents for FAZ 3000-PIR-2
Page 115: ...115...
