Conrad Electronic FAZ 3000-PIR-2, Operating Instructions Manual

Page: 64 / 115

64
c) Sensors
The ‘sensor’ menu item has a total of four submenus:
• Add: Register sensor and enter names
• Delete: Delete sensors
• Names: Modify a sensor’s name
• Attributes : Modify a sensor’s attributes: Internal sensor: yes/no
Closure group: yes/no
Furthermore, the peripheral devices such as the alarm dialler, PC interface, siren interface, second
remote control etc., are all managed via the ‘sensors’ menu. You can find the procedures for managing
these devices in their respective specifications.
1. Add sensors

On pages 46 to 53 you will find a very detailed description of the registration procedure
for the initial installation of the complete set (alarm base station with door/window
detector, PIR motion detector and remote control).
Above all, however, make sure
that you observe the sensor’s user manual and page 47 of this user manual.
If you purchase a new sensor, such as an additional smoke detector, PIR motion detector or door/
window detector, then this can be registered with the alarm base station as follows:
• You must be on the main level. The LCD should appear as on the right,
for example, with the time and the date.
• Briefly press the ‘ Menü a/A ’ button on the operating unit of the ‘FAZ
3000-Z’ alarm base station.
• Using the ‘ ’ and ‘ ’ buttons, select the ‘
sensors sensors
sensors sensors
sensors
’ menu. See the figure
on the right.
• Confirm your selection by briefly pressing the ‘ OK ’ button. ‘
sensors sensors sensors sensors sensors
add add add add add
’ is displayed on the LCD.
• Press the ‘ OK ’ button again. The symbol ‘
X X
X X
X
’ stands for the number of
the next free sensor (X = number of sensors that have been registered
up to now + 1). Now you may have to select the device type that you
wish to register using the ‘ ’ button. See page 47.
• Go to the sensor that you wish to register and insert the batteries with
the correct polarity in the battery compartment (you will find a detailed
description in the respective sensor’s user manual).
• The sensor establishes contact with the base station by sending out
a radio signal. The sensor’s LED briefly lights up, and the base station
emits a short signal tone to confirm that it has received the signal.
sensors
add
sensors
troubles
disarm
10:20 05.02
sensor X
clear