Conrad Electronic FAZ 3000-PIR-2, Operating Instructions Manual

Page: 94 / 115

94
4. Dialout number
The alarm dialler can also, of course, be connected to a telephone system’s extension. Depending
on the telephone system used, it may be necessary to first dial a ‘0’ for the dialout number. This
can be set in the alarm base station.

Some telephone systems allow a so-called ‘automatic dialout number’ to be programmed.
For this check the telephone system’s user manual.
Activate the dialout number either on the alarm base station or the telephone system.
The dialout number using the ‘FAZ 3000-Z’ alarm base station is only possible using
the prefix ‘0’ (zero). If, for example, your telephone system requires a ‘1’ or ‘2’ etc.,
then this should be programmed as a telephone number with a subsequent pause. See
page 93.
To set the dialout number, proceed as follows:
• You must be on the main level. The LCD should appear as on the right,
for example, with the time and the date.
• Briefly press the ‘ Menü a/A ’ button on the control unit of the ‘FAZ 3000-
Z’ alarm base station.
• Use the ‘ ’ and ‘ ’ buttons to select the ‘
al.dialer al.dialer al.dialer al.dialer al.dialer
’ menu.
• Confirm your selection by briefly pressing the ‘ OK ’ button.
• Select the ‘
prefix prefix prefix prefix prefix
’ menu using the ‘ ’ and ‘ ’ buttons.
• Confirm your selection by briefly pressing the ‘ OK ’ button.
The state that is currently set appears on the LCD (factory set to ‘ no ’).
• Use the ‘ ’ and ‘ ’ buttons to select the setting you require:
‘
y e s y e s
y e s y e s y e s
’: Dialout number switched on via ‘0’
‘
no no
no no no
’: Dialout number switched off
• Pressing the ‘ OK ’ button applies the setting.
• Exit the menu by pressing the ‘ C ’ button twice. This returns you to the
normal display mode (main level).
al. dialer
troubles
disarm
15:22 23.02
al. dialer
trigger
al. dialer
prefix
prefix
yes
prefix
n o
al. dialer
silent al.
disarm
15:23 23.02