Conrad Electronic FAZ 3000-PIR-2, Operating Instructions Manual

Page: 100 / 115

100
You can change the conditions for setting off the alarm as follows:
• You must be on the main level. The LCD should appear as on the right,
for example, with the time and the date.
• Briefly press the ‘ Menü a/A ’ button on the control unit of the ‘FAZ 3000-
Z’ alarm base station.
• Use the ‘ ’ and ‘ ’ buttons to select the ‘
PC interf. PC interf.
PC interf. PC interf.
PC interf.
’ (‘PC interface’)
menu.
• Confirm your selection by briefly pressing the ‘ OK ’ button.
• Confirm your selection by briefly pressing the ‘ OK ’ button.
Please note the position of the cursor (‘_’, see arrow in the figure on
the right). When the cursor is located precisely at this position (at the
far right), you can use the ‘ ’ and ‘ ’ buttons to switch between the three
different states ‘
d i s a r m e d d i s a r m e d
d i s a r m e d d i s a r m e d
d i s a r m e d
’, ‘
internally armed internally armed
internally armed internally armed
internally armed
’ and ‘
e x - e x -
e x - e x -
e x -
t e r n a l l y a r m e d t e r n a l l y a r m e d t e r n a l l y a r m e d t e r n a l l y a r m e d t e r n a l l y a r m e d
’.
Here, the dash and number sequences correspond to the settings in
the tables on pages 98 and 99.
• Using the ‘ C ’ and ‘ ’ buttons you can select the required entry position
(cursor ‘_’ is located beneath the selected position).
You can change the value using the ‘ ’ and ‘ ’ buttons.
‘
1 1
1 1
1
’: The alarm is triggered via the PC interface
‘
0 0
0 0 0
’: The alarm not is triggered via the PC interface
Positions that have a ‘
- - - - -
’ cannot be changed.
If the cursor is located at the far right (see the arrow in the figure on
the right) you can use the ‘ ’ and ‘ ’ buttons to switch between the three
different states ‘
d i s a r m e d d i s a r m e d d i s a r m e d d i s a r m e d d i s a r m e d
’, ‘
internally armed internally armed internally armed internally armed internally armed
’ and ‘
e x - e x - e x - e x - e x -
t e r n a l l y a r m e d t e r n a l l y a r m e d t e r n a l l y a r m e d t e r n a l l y a r m e d t e r n a l l y a r m e d
’.
• Pressing the ‘ OK ’ button applies the new settings.
• Exit the menu by pressing the ‘ C ’ button twice. This returns you to the
normal display mode (main level).
PC interf.
troubles
disarm
21:27 25.02
PC interf.
trigger
disarm
--000_
ext. arm
-0000_
int. arm
0-000_
disarm
21:33 25.02
ext. arm
-0100
ext. arm
-0100_
ext. arm
-0000
PC interf.
trigger