Conrad Electronic FAZ 3000-PIR-2, Operating Instructions Manual

Page: 76 / 115

76
5. Programming an access code for ‘internally armed’
To prevent the alarm system from being switched to ‘internally armed’ or from ‘internally armed’
to ‘disarmed’ by unauthorised persons, an access code can be programmed for the state change.
This access code is only valid for the buttons on the base station itself (not
for a remote control) and is requested after a button is pressed.
The state is only changed after you have entered the correct code. If
switching back and forth takes place within a few seconds, the code is
not requested again.
Make a note of the code and keep it in a safe place.

You can deactivate the access code by entering ‘0000’ as the code.
The access code for ‘internally armed’ is programmed as follows:
• You must be on the main level. The LCD should appear as on the right,
for example, with the time and the date.
• Briefly press the ‘ Menü a/A ’ button on the control unit of the ‘FAZ 3000-
Z’ alarm base station.
• Use the ‘ ’ and ‘ ’ buttons to select the ‘
setup setup setup setup setup
’ menu.
• Confirm your selection by briefly pressing the ‘ OK ’ button.
• Select the ‘
code intern code intern
code intern code intern
code intern
’ menu using the ‘ ’ and ‘ ’ buttons (‘code
for switching to internally armed’).
• Confirm your selection by briefly pressing the ‘ OK ’ button.
• You can now use the number buttons to enter any four-digit code, for
example ‘1234’ or ‘9876’ and so on.
You can use the ‘ C ’ button to correct any incorrect entry you have
made.
If you want to switch off the access code (no code request for
‘internally armed’), enter ‘0000’ as the code.
• Pressing the ‘ OK ’ button applies the setting.
• Exit the menu by pressing the ‘ C ’ button twice. This returns you to the
normal display mode (main level).
int. arm
code: ----
setup
troubles
disarm
20:17 08.02
setup
set time
code int.
code: ----
setup
code intern
code int.
code: 0000
disarm
20:27 08.02
code int.
code: 123-
setup
code intern