Conrad Electronic FAZ 3000-PIR-2, Operating Instructions Manual

Page: 81 / 115

81
2. Setting the duration for the internal siren
The duration for the internal siren is factory set to 60 seconds, however, you can adjust this time
to a value between 10 and 300 seconds.
Caution!
The maximum duration for an acoustic alarm that sounds outside is restricted by law
to 3 minutes (an external flash can signal for longer). This may vary at health resorts,
for example. Therefore, as a precaution, check this out with your local council.
The duration for indoor areas is not normally affected by this restriction. However, if
an internal alarm signal is very loud and is also clearly audible outside, then the legal
restriction may apply here too!
To set the duration, proceed as follows:
• You must be on the main level. The LCD should appear as on the right,
for example, with the time and the date.
• Briefly press the ‘ Menü a/A ’ button on the control unit of the ‘FAZ 3000-
Z’ alarm base station.
• Use the ‘ ’ and ‘ ’ buttons to select the ‘
int. siren int. siren int. siren int. siren int. siren
’ menu (‘internal
siren’).
• Confirm your selection by briefly pressing the ‘ OK ’ button.
• Select the ‘
duration duration duration duration duration
’ using the ‘ ’ and ‘ ’ buttons. See the figure
on the right.
• Confirm your selection by briefly pressing the ‘ OK ’ button.
The duration that is currently set appears on the LCD (factory set to 60
seconds).
• Use the ‘ ’ and ‘ ’ buttons to select the required duration. You can set
the duration to a value between 10 and 300 seconds (in increments of
10 seconds). To make a quick setting keep the ‘ ’ or ‘ ’ button pressed
for a few seconds.
• Pressing the ‘ OK ’ button applies the setting.
• Exit the menu by pressing the ‘ C ’ button twice. This returns you to the
normal display mode (main level).
int. siren
troubles
disarm
21:27 08.02
int. siren
trigger
int. siren
duration
duration
90 sec.
duration
60 sec.
int. siren
duration
disarm
21:33 08.02