Conrad Electronic FAZ 3000-PIR-2, Operating Instructions Manual

Page: 80 / 115

80
You can change the conditions for setting off the alarm as follows:
• You must be on the main level. The LCD should appear as on the right,
for example, with the time and the date.
• Briefly press the ‘ Menü a/A ’ button on the control unit of the ‘FAZ 3000-
Z’ alarm base station.
• Use the ‘ ’ and ‘ ’ buttons to select the ‘
int. int.
int. int.
int. siren siren
siren siren
siren
’ menu (‘internal
siren’).
• Confirm your selection by briefly pressing the ‘ OK ’ button. ‘
trigger trigger trigger trigger trigger
’
appears at the bottom of the LCD (‘alarm trigger’).
• Confirm your selection by briefly pressing the ‘ OK ’ button.
Please note the position of the cursor (‘_’). If the cursor is located pre-
cisely at this position (at the far right), you can use the ‘ ’ and ‘ ’ buttons
to switch between the three different states ‘
disarmed disarmed
disarmed disarmed disarmed
’, ‘
inter- inter-
inter- inter- inter-
n a l l y a r m e d n a l l y a r m e d
n a l l y a r m e d n a l l y a r m e d
n a l l y a r m e d
’ and ‘
e x t e r n a l l y a r m e d e x t e r n a l l y a r m e d
e x t e r n a l l y a r m e d e x t e r n a l l y a r m e d
e x t e r n a l l y a r m e d
’.
Here, the dash and number sequences correspond to the settings in
the tables on pages 78 and 79.
• Using the ‘ C ’ and ‘ ’ buttons you can select the required entry position
(cursor ‘_’ is located beneath the selected position).
You can change the value using the ‘ ’ and ‘ ’ buttons.
‘
1 1 1 1 1
’: Internal siren is triggered
‘
0 0
0 0
0
’: Internal siren is not triggered
Positions that have a ‘
- -
- - -
’ cannot be changed.
If the cursor is located at the far right (see the arrow in the figure on
the right), then you can switch between the three different states
‘
d i s a r m e d d i s a r m e d
d i s a r m e d d i s a r m e d d i s a r m e d
’, ‘
i n t e r n a l l y a r m e d i n t e r n a l l y a r m e d
i n t e r n a l l y a r m e d i n t e r n a l l y a r m e d i n t e r n a l l y a r m e d
’ and ‘
e x t e r n a l l y e x t e r n a l l y
e x t e r n a l l y e x t e r n a l l y e x t e r n a l l y
armed armed
armed armed
armed
’ using the ‘ ’ and ‘ ’ buttons.
• Pressing the ‘ OK ’ button applies the new settings.
• Exit the menu by pressing the ‘ C ’ button twice. This returns you to the
normal display mode (main level).
int. siren
troubles
disarm
20:17 08.02
int. siren
trigger
disarm
--111_
ext. arm
-1111_
int. arm
1-111_
disarm
20:27 08.02
ext. arm
-1101
ext. arm
-1101_
ext. arm
-1111
int. siren
trigger