How It Works
The Process (Drying) Cycle
(W1600 - 5000)
Process air from the hopper is pulled into the dryer, through the process filter and
then into the process blower inlet. Air exits the process blower and then enters the
intercooler, then passes through the desiccant wheel, where moisture is removed.
The air exits the dryer and passes through the precooler (if installed), then into the
process heat source. After the air exits the process heat source it then goes into the
hopper inlet through internal piping, then to the spreader cone, which evenly dis-
tributes the air through the material.
The Cooling Cycle
(All models except W2400, W4000 and W5000)
Regenerated desiccant must be cooled before it rotates back into the process cycle.
The process blower pushes the process air through the desiccant wheel. A small
amount of the process air is diverted through a small section of the desiccant wheel
to cool the air. The cooling air then returns back to the process air stream at the
start of the process cycle.
The Regeneration Cycle
The regeneration blower pulls air through the regeneration filter into the dryer’s
regeneration heater. The air is heated to 350°F {177°C} before it is pushed into the
“wet” section of the desiccant wheel. The hot air purges moisture from the
desiccant. The moist air is blown out the moisture exhaust at the top of the dryer.
The Process (Drying) Cycle
(W600 - 1000)
Process air from the hopper is pulled into the dryer, through the process filter and
then into the process blower inlet. Air exits the process blower and then enters the
aftercooler, then passes through the desiccant wheel, where moisture is removed.
The air exits the dryer and passes through the precooler (if installed), then into the
process heat source. After the air exits the process heat source it then goes into the
hopper inlet, then to the spreader cone, which evenly distributes the air through the
material.
2-4
l D e s c r i p t i o n
NOTE:
Changing the regen-
eration cycle temperature
setpoint requires a
Maintenance level user
login.
Activating the optional dew-
point control will override
the temperature setting.
✐
Summary of Contents for Carousel Plus UGD043-1216
