3
Installa
tion
I n s t a l l a t i o n l
3-5
Connecting the Deliver y Air RTD Probe
The delivery air RTD probe monitors the temperature of the drying air as it enters the hop-
per. If the probe is not installed correctly, temperature readings will be inaccurate.
1
Insert the probe at the inlet to the
hopper
. The end of the probe must not touch the walls
of the inlet. The tip of the probe should be approxi-
mately in the center of the tube. Tighten the compres-
sion fittings to lock the probe in place.
2
Plug the probe’s cable into the recep-
tacle labeled process on the left side
of the electrical enclosure.
Hand tight-
en the connector. Coil any excess cable
and secure it with a wire tie.
Connecting the Process Protection RTD
(Optional)
1
Insert the probe into the 1/8 inch NPT coupling
on heater manifold (before the hopper
inlet). The manifold will be threaded for the process protection connection.
2
Plug the probe’s cable into the receptacle labeled Process Protection on the left side
of the electrical enclosure.
Hand tighten the connector. Coil any excess cable and
secure it with a wire tie.
Connecting the Setback RTD Probe
(Optional)
1
Insert the probe in the hopper outlet
at the top of the hopper. The end of the probe
must not touch the walls of the inlet. The tip of the probe should be approximately in the
center of the tube. Tighten the compression fittings to lock the probe in place.
2
Plug the probe’s cable into the receptacle labeled setback on the left side of the elec-
trical enclosure.
Hand tighten the connector. Coil any excess cable and secure it with a
Delivery Air RTD
When configured as
a central dryer, moni-
toring the drying air
temperature is not
necessary since there
is no delivery air
heater in the system.
Therefore, installa-
tion and connection
of the RTD probe is
not applicable.
Summary of Contents for Carousel Plus UGD043-1216
