14-102
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 14 Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing the Cisco ASR 1001 Router Power Supplies
Figure 14-75
shows both the AC and DC power supplies for the Cisco ASR 1001 Router.
Figure 14-75
Cisco ASR 1001 Router AC Power Supply and DC Power Supply
This section contains the following topics:
•
Installing the AC Power Supply into Cisco ASR 1001 Router, page 14-103
•
Removing AC Power Supply from the Cisco ASR 1001 Router, page 14-105
•
Installing DC Power Supply into Cisco ASR 1001 Router, page 14-107
•
Removing DC Input Power from the Cisco ASR 1001 Router, page 14-113
Warning
The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed.
Statement 1077
Warning
When you install the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Warning
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
1
AC and DC power supply fasteners
5
DC power supply ground symbol
2
AC power supply inlet
6
DC power supply terminal block connection
3
DC power supply negative (-) connection
7
AC and DC power supply handles
4
DC power supply positive (+) connection
—
—
-4
8
V/-60V 14A
5
6
2
4
1
1
3
8
7
8
1
20769
3
100-240 V~
5-2A
50-60Hz
3
1
