11-7
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 11 Cisco ASR 1013 Router Overview and Installation
Cisco ASR 1013 Router Description
Cisco ASR 1013 Router Power Zones
Internal fans draw cooling air into the chassis and across internal components to maintain an acceptable
operating temperature. (See
Figure 11-2
.) The fans are built into the power supply allowing fan and
power supply replacement. A two-hole grounding lug is located on the bottom rear of the chassis (see
Figure 11-2
, callout 6). Four power supplies, either AC power supplies or DC power supplies, are
accessed from the rear of the router. The power supply bays are numbered from bottom to top: 0, 1, 2,
and 3 respectively.
The Cisco ASR 1013 Router has two power zones:
•
Power zone 1(top half of chassis) includes slots:
–
PS1-A
–
PS1-B
–
Carrier card slots 3, 4, and 5
–
RP1
–
FP1
•
Power zone 0 (bottom half of chassis) includes slots:
–
PS0-A
–
PS0-B
–
Carrier card slots 0, 1, and 2
–
RP0
–
FP0
Note
Do not combine AC and DC power supplies in the same chassis.
Note
Cisco ASR 1013 Router supports only Cisco ASR1000-RP2.
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
Warning
Before you install, operate, or service the system, read the
Regulatory Compliance and Safety
Information for Cisco ASR 1000 Series Aggregation Services Routers
publication. This document
provides important safety information you should know before working with the system.
Statement 200
Note
You have already unpacked your chassis and read all the site requirements for your new equipment.
Proceed with the installation.
