9-20
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 9 Cisco ASR 1002-F Router Overview and Installation
Installing the Cisco ASR 1002-F Router in a Rack
Two-Post Rack Installation
The Cisco ASR 1002-F Router can be installed on a two-post rack, either a 19-inch or 23-inch rack.
Note
Inner clearance (the width between the inner sides of the two posts or rails) must be at least 19 inches
(48.26 cm). The height of the chassis is 3.47 inches (8.8 cm). Airflow through the chassis is from front
to back.
Caution
If you are using a two-post rack, secure the rack to the floor surface to prevent tipping and avoid bodily
injury and component damage.
Step 1
Position the chassis so the front is closest to you and lift it carefully into the rack. To prevent injury,
avoid any sudden twists or moves.
Figure 9-15
shows the Cisco ASR 1002-F Router on a two-post rack.
Figure 9-15
Installing the Cisco ASR 1002-F Router on a Two-Post Equipment Rack
Step 2
Slide the chassis into the rack, pushing it back until the brackets meet the mounting strips or posts on
both sides of the rack.
Step 3
Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets with the
holes on the rack or mounting strip.
Step 4
For each bracket, insert and tighten two screws to the rack on both sides.
1
Rack equipment rail
2
Front rack-mount bracket ear and holes
274500
S
PA-4XOC
3-PO
S
S
T
A
T
U
S
0
1
2
3
C
/A
A/
L
C
/A
A/
L
C
/A
A
/L
C
/A
A
/L
0
1
2
