Christie DS+4K, User Manual

Page: 98 / 144

Section 4: Maintenance
4-6 User’s Manual
WARNING
Handle lamp with care. Lamp may explode if dropped.
Wear protective clothing and safety goggles when
handling lamps.
Use only Christie approved lamps provided in Lamp and
Filter Service Kits for your projector.
1. Press to power down the projector. Wait at least 5 minutes to allow the
internal cooling fans to stop before unplugging the projector. This wait period
is also required to allow the lamp to sufficiently cool before handling.
WARNING
Always power down and unplug the projector prior to
servicing.
Allow the lamp to cool before handling.
2. Using a screwdriver, loosen the 2 screws from the lamp door located at the
back of the projector, below the input panel. (Figure 4.2.)
Figure 4.2.
3. Pull (out) and turn the lamp lock lever, which is located to the left of the lamp
module, a quarter turn counter clockwise to the “unlock” position. (Figure
4.3.)
Figure 4.3.
4. Grasp the lamp by its housing only and pull it straight out (lamp slides along
guides) until it’s free. (Figure 4.4.) Discard the lamp using safe
disposal/recycling practices or contact CHRISTIE for a possible re-lamping
program.