Christie DS+4K, User Manual

Page: 21 / 144

Section 2: Installation and Setup
User’s Manual 2-17
.
Regardless of how it is assigned, once a projector has a valid and unique address it
will respond to commands sent to this address. To determine the projector’s current IP
address, consult the Status or Communications menus.
Refer to Section 3 for further information about setting up and using a projector
connected via Ethernet.
Log on to www.christiedigital.com for detailed information on ChristieNET

.
General Purpose Input Output
The GPIO connector on the input panel can be used to provide a method of interfacing
a wide range of external I/O devices to the projector.
Refer to Appendix E: System Integration for complete details on pin configuration
and how to program the various pins on the connector.
Plug the line cord to the AC receptacle located at the back of the projector, below the
input panel, and the 3-pronged end into a grounded AC outlet. The input voltage to the
projector must be capable of 100 – 240 VAC in 500W and 1000W models and 200-
240VAC in 1200W models. (See also Section 6 – Specifications for complete details
on all power requirements.)
Use the approved North American-rated line cord supplied with the projector. If you
are connecting to an area outside of North America make sure you are using an
appropriately rated line cord.
Always power down the projector before unplugging the AC line cord. Wait 5-10
minutes for the main exhaust fan to turn off and for the lamp to cool sufficiently
before unplugging the projector.
WARNINGS
Do not attempt operation if the AC supply and cord are
not within the specified voltage and power range.
Wait for the cooling fans to turn off before unplugging the
projector.
2.5 System
Integration
-
GPIO Connector
2.6 Power
Connection