Section 6: Specifications
6-2
User’s Manual
Standard Analog RGB or YPbPr
(Interlaced or Progressive Scan Format)
Horizontal Frequency Range
31 – 120 kHz
Vertical Frequency Range (See Note 2)
23.97 – 150 Hz
Scan format
Interlaced or progressive
Pixel Clock Rate (max.)
220 MHz max
Signal Format
Analog RGB, YPbPr, Composite (on
“G, PB” input and S-video (luma on
“R/Pr/Y” input and chroma on
“B/Pb/C” input)
Input Levels
R, G, B, - with sync:
1.0V
p-p
±
2 dB
R, G, B, - without sync:
0.7V
p-p
±
2 dB
Pb,
Pr
0.7
p-p
±
2 dB
Nominal Impedance
75 ohms
Note 2: Value specifies frame rate of non-interlaced sources and field rate for
interlaced sources. Frame/field rates higher than the maximum refresh rate of the
panels will be displayed at a lower rate (i.e., frames will be dropped).
Sync
(Interlaced or Progressive Scan Format)
Horizontal Frequency Range
31 – 120 kHz
Vertical Frequency Range (See Note 1)
23.97 – 150 Hz
Sync Type
Separate H and V, direct or swapped
Composite
(bi-level, tri-level, XOR, OR)
Sync-On-Green/luma
(bi-level, tri-
level)
Serration and /or Equalization pulses
MacroVision
for standard &
progressive video
Polarity (See Note 3)
Positive or Negative
Input Levels (See Note 3)
0.5V
pp
– 4.0V
pp
DC Offset (See Note 3)
±
3V
Nominal Impedance (See Note 3)
75 ohms
Horizontal Sync Duty Cycle
3% min, 20% max
Note 3: Does not apply to sync-on-green/luma.
Composite Video and S-Video
Signal Formats
Composite-video
(CVBS),
S-video
Y/C)
Video Standards
NTSC, NTSC 4.43, PAL, PAL M,
PAL N, PAL60, SECAM
Input Levels
Composite-video:
1.0 Vp-p
±
3 db (including sync tip)
S-video luma (Y):
1.0 Vp-p
±
3 dB (including sync tip)
S-video chroma (C):
630 mV nominal (burst)
DC Offset
±
2 V
Nominal Impedance
75 ohms
Return Loss (VSWR)
20 dB min (1.2:1 max.) @ 6 MHz
Inputs
'
Summary of Contents for DS+4K
