Christie DS+4K, User Manual

Page: 6 / 144

Section 2: Installation and Setup
2-2 User’s Manual
Connect the Line Cord
The North American rated line cord is provided with each projector.
Plug the line cord to the AC receptacle located on the right hand side of the projector
and the 3-pronged end into a grounded AC outlet. The input voltage to the projector
must be capable of 100 – 240 VAC in 500W and 1000W models and 200-240VAC in
1200W models. (See also Section 6 – Specifications for complete details on all power
requirements.)
Use the approved North American-rated line cord supplied with the projector. If you
are connecting to an area outside of North America make sure you are using an
appropriately rated line cord.
Turn the Projector ON
Press the
POWER
button on either the remote or built-in keypad to turn the
projector on. Wait a few minutes to allow the projector to warm up. The LED status
window displays an active pattern of segments to indicate the projector is changing its
state from powered down to powered up. The message “On” appears in the display
when the projector has completed its initialization and is ready for use.
Select a Source
Press one of the input keys on the remote or built-in keypad to select and display the
image for the source you connected in Step 3.
Adjust Image
Adjust the more common image settings, such as Brightness, Contrast, Gamma,
Focus, Zoom etc. using the direct keys on the IR remote.
You can also access the menu system and adjust these and other image settings by
pressing
Menu
on the remote.
Step 4
'
Step 5
'
Step 6
'
Step 7
'