Canon CLC 1130, Service Manual

Page: 541 / 965

CHAPTER 11 INSTALLATION
11-44
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
16) Call the service station, and find out whether
initial settings work has ended. If it ended in
failure, start over by repeating steps 11)
through 13), i.e., from initializing the RAM,
and complete initial settings.
Be sure to find out whetehr
the settings of the
diagnostic device are
correct by referring to the
settings kept at the service
station.
17) Check to find out whether a call may be
placed to the computer at the service
station using the diagnostic device.
Press the push switch [18] (SW4) on the
PCB. In response, LED6 [24] (red) will turn
on: if the transmission ends successfully,
LED6 [24] (red) will turn off; if it ends in
failure, it will start to flash.
If you press the push switch SW4 [18]
while LED6 [24] is flashing, transmission
will occur once again.
If you press the push switch (SW1) [25]
while LED6 [24] is flashing, transmission
will be canceled.
Figure 11-716
18) Check to make sure that communication
between diagnostic device and copier is
normal.
Connect the copier’s power plug, and turn
on the power switch to make user that
LED2 [26] (orange) flashes.
Figure 11-717
LED1 LED2 LED3
2
1
LED5
LED6
LED4
IC6
SW1
SW4
SW3
6
1
BAT1
CN4
1
2
CN3 CN2
[24]
SW2
[25]
[18]
LED1 LED2 LED3
2
1
LED5
LED6
LED4
IC6
SW1
SW4
SW3
6
1
BAT1
CN4
1
2
CN3 CN2
[26]
SW2