Canon CLC 1130, Service Manual

Page: 348 / 965

COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
7-85
CHAPTER 7 PICK-UP / FEEDING SYSTEM
8. Replacing the Registration Roller
Releasing Spring Clutch Assembly
1) Remove the solenoid plate, and loosen the
hex-hole screw [1] using a hex key; then,
detach the spring clutch assembly [2].
Figure 7-831
2) Clean the shaft to which the spring clutch
assembly was attached with alcohol.
3) Loosen the hex-hole screw of the new
spring clutch, and mount it to the shaft.
At this time, keep the spring clutch butted
against the E-ring side.
Further, when tightening the hex-hole
screw, be sure that the screw and the D-
cut of the shaft are perpendicular.
4) Apply several drops of lubricating oil in
the gap [5] between the gear [3] and the
control ring [4] of the spring clutch.
Figure 7-832
5) Thereafter, rotate the gear of the spring
clutch several times so that the oil spreads
in the gap between the gear and the
control ring; then, apply several drops of
oil once again.
6) Repeat steps 4 ) and 5 ) several times until
about ten drops of oil have been applied in
total.
7) Wipe off the oil that has spread to the
control ring.
Figure 7-833
[2] [1]
[3] [4]
[5]
(viewed from the front)