Canon CLC 1130, Service Manual

Page: 230 / 965

COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
6-65
CHAPTER 6 IMAGE FORMATION SYSTEM
1. If you have
disconnected a
connector when
removing the Y/M/C
developing assembly,
be sure to clean the
inside of the ATR
sensor connector.
2. When mounting a
developing assembly to
the copier, be sure to
dry wipe its bias
electrode with lint-free
paper in advance to
prevent developing
faults.
Figure 6-630
4. Removing the ATR Sensor of the Y/
M/C Developing Assembly
1) Remove the Y/M/C developing assembly.
2) Remove the screw [1], and slide the
developing blade cover [2] to the right to
remove. (In the case of the Y developing
assembly, slide it to the left.)
Figure 6-631
3) Remove the four screws [3], and
disconnect the connector [4]; then,
remove the developing blade unit.
When assembling the
parts, force down the
developing blade unit, and
screw it in place.
4) Remove the three screws [5], and detach
the ATR sensor [6].
If you have replaced the
ATR sensor, be sure to
replace the developer and
select the appropriate
concentration in service
mode.
[2] [1]
[4]
[3]
Figure 6-632
Force down. Force down.
Figure 6-633
[5] [6]