Canon CLC 1130, Service Manual

Page: 235 / 965

CHAPTER 6 IMAGE FORMATION SYSTEM
6-70
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.3 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
6. Adjusting the S-B Gap
If you have replaced the developing blade,
make adjustments using the S-B gap gauge
(FY9-3044). See the following for the S-B gap
of each sleeve:
Insert two gauges (see the guide above for
each color; on both ends) into the gaps
between the developing blade and the sleeve,
and secure the developing blade in place.
If you insert the
developing assembly at an
angle, its gear at the rear
can damage the
photosensitive drum.
When inserting the
developing assembly, be
sure that it is horizontal in
relation to the rails, and
take extra care not to bring
it in contact with the drum.
Further, when inserting the
black developing
assembly, be sure that it
will not ride over the rails.
7. Replacing the Developer
1) Open the hopper unit fully.
2) Put a plastic bag [1] against the discharge
opening. (An appreciable amount of
developer will fall out.)
3) Remove the cap [2] of the discharge
opening found at the lower front of the
developing assembly whose developer is
to be replaced.
Developer color S-B gap
Yellow 0.62mm
Cyan 0.74mm
Magenta 0.74mm
Black 0.48mm
Figure 6-647
[1]
[2]
Figure 6-646