Canon CLC 1130, Service Manual

Page: 842 / 965

COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.3 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
13-253
CHAPTER 13 TROUBLESHOOTING
DOC-REC
FEED-ADJ
DX-XS
DA-XE
DA-YS
DA-YE
DS-DOC
ATT-T-A
ATT-T-B
RG-XA
RG-XB
RG-Y
TR-DLY-A
TR-DLY-B
ATT-CHK
ATT-ON
RGST-CHK
RGST-ON
TR1-CHK
TR2-CHK
TR1-ON
TR2-ON
TR-END-A
TR-END-B
fine-adjustment of the original detection area
fine-adjustment of the original detection area
fine-adjustment of the original detection area
fine-adjustment of the original detection area
adjustment of the slice level for original
detection
adjustment of side A attraction timing for the
transfer drum
adjustment of side B attraction timing for the
transfer drum
adjustment of registration in sub scanning
direction of side A on the transfer drum
adjustment of registration in sub scanning
direction of side B on the transfer drum
adjustment of registration in main scanning
direction on the transfer drum
Use it to adjust the transfer delay on side A of
the transfer drum.
Use it to adjust the transfer delay on side B of
the transfer drum.
specification of position of attraction on the
transfer drum during ATT-ON (1: 2-sheet
retention of sides B and A; 2: retention on
side A, 3: retention on side B)
executes attraction of paper to the transfer
drum according to ATTCHK (OK key to
start; auto stop)
specifies position of attraction on the transfer
drum during RGST-ON (1: 2-sheet retention
on sides B and A, 2: retention on side A, 3:
retention on side B)
executes printing for checking registration
(retention side) using C according to RGST-
CHK (OK key to start; auto stop)
specifies position of attraction on the transfer
drum during TR1-ON (1: 2-sheet retention of
sides B and A, 2: retention on side A, 3:
retention on side B)
specifies position of attraction on the transfer
drum during TR2-ON (1: 2-sheet retention of
sides B and A, 2: retention on side A, 3:
retention on side B)
executes printing for checking the leading
edge margin (1 mm) according to TR1-CHK
(OK key to start; auto stop)
executes printing for checking the leading
edge margin (8 mm) according to TR2-CHK
(OK key to start; auto stop)
adjusts the falling edge (trailing edge margin)
of transfer high voltage for side A retention
adjusts the falling edge (trailing edge margin)
of transfer high voltage for side B retention
-99 to +99
-99 to +99
-99 to +99
-99 to +99
0 to 31
-10 to +10
-10 to +10
-47 to +47
-47 to +47
-70 to +70
-10 to +10
-10 to +10
1 to 3
---
1 to 3
---
1 to 3
1 to 3
---
---
0 to 25
0 to 25
Cont'd