Canon CLC 1130, Service Manual

Page: 343 / 965

CHAPTER 7 PICK-UP / FEEDING SYSTEM
7-80
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
2) Remove the two screws [3], and detach
the scraper [4].
Figure 7-817
5. Removing the Attraction Roller
1) Remove the attraction roller unit.
2) Remove the scraper of the attraction roller.
3) Remove the resin fixing ring [1] at the
front, and detach the attraction roller [2].
Figure 7-818
6. Replacing the Attraction Roller Unit
Spring Clutch Assembly
1) Remove the attraction roller unit.
2) Using a hex screw, loosen the hex-hole
screw [1], and remove the spring clutch
assembly [2] from the registration roller
assembly rear.
3) Clean the shaft to which the spring clutch
was mounted.
4) Loosen the hex-hole screw of the new
spring clutch assembly.
5) Mount the new spring clutch assembly to
the shaft.
While doing so, keep the spring clutch
assembly butted against the E-ring side.
When loosening the hex-hole screw, be
sure that the screw and the D-cut of the
shaft are perpendicular.
[1]
[2]
[1]
[2]
[3]
[4]
Figure 7-819