Canon CLC 1130, Service Manual

Page: 593 / 965

CHAPTER 13 TROUBLESHOOTING
13-26
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
1. Fix the side of the
transfer drum sheet with
a long hole temporarily
in place so that that the
gap between the left
side of the transfer drum
sheet and the edge of
the transfer ring is about
0.5 mm.
2. Then, lightly pull the
transfer drum sheet to
the right so that the
middle of the sheet will
not become slack, and
attach the right side of
the sheet where a round
hole is found.
3. At this time, check to
make sure that the right
edge of the transfer
drum sheet will not
overlap the edge of the
transfer ring; otherwise,
shift the left side of the
sheet where a long hole
is found, and start over
with step 2.
6) Let the transfer drum sheet drop on its
own weight, and remove the backing
paper from both sides of the sheet.
7) without holding the transfer drum sheet,
turn the front side of the transfer ring to
wrap it around the transfer drum.
Figure 13-242
Transfer rings
No overlapping.
Pull lightly to remove
the slack in the middle.
Figure 13-243
Figure 13-244