Brocade Communications Systems Network Advisor 12.0.0, User Manual

Page: 874 / 1505

826 Brocade Network Advisor SAN User Manual
53-1002696-01
Editing thresholds
24
3. Select the threshold you want to change and click Edit.
The Edit Protocol Error Threshold dialog box displays.
4. Complete step 4 through step 5 in “Adding a Protocol Error threshold” on page 818.
5. Click OK on the Edit Protocol Error Threshold dialog box.
If the threshold has already been assigned to ports, an “Are you sure you want to make the
requested changes to this threshold on “X” ports?” message displays. Click OK to close.
To assign this threshold to fabrics, switches, or switch ports, refer to “Assigning thresholds” on
page 821.
6. Click OK on the Port Fencing dialog box.
Editing a State Change threshold
NOTE
This threshold is only available for Fabric OS devices running 6.3 or later.
NOTE
This feature requires a Trial or Licensed version.
Use to block a port when a state change violation type meets the Fabric OS switch threshold. For
4 Gbps Router, Extension Switches and Blades only, when you apply this threshold on an E Port, the
threshold is also applied to the VE Ports (internally by Fabric OS).
To edit an State Change threshold, complete the following steps.
1. Select Monitor > Fabric Watch > Port Fencing.
The Port Fencing dialog box displays.
2. Select State Change (Fabric OS only) from the Violation Type list.
3. Select the threshold you want to change and click Edit.
The Edit State Change Threshold dialog box displays.
4. Complete step 4 through step 7 in “Adding a State Change threshold” on page 820.
5. Click OK to add the state change threshold to the table and close the Edit State Change
Threshold dialog box.
To assign this threshold to fabrics, switches, or switch ports, refer to “Assigning thresholds” on
page 821.
6. Click OK on the Port Fencing dialog box.