Brocade Communications Systems Network Advisor 12.0.0, User Manual

Page: 134 / 1505

86 Brocade Network Advisor SAN User Manual
53-1002696-01
SAN End node display
5
1. Select Server > Options.
The Options dialog box displays.
2. Select SAN Display in the Category list.
3. Click Reset Display.
4. Click Yes on the reset confirmation message.
The display and view settings are immediately reset to the default display settings (as detailed
in the Default display Settings table (
Table 19 )).
5. Click Apply or OK to save your work.
SAN End node display
The connectivity map can be configured to display or not display end nodes. This option enables
you to set the end node display for all newly discovered fabrics. Note that disabling end node
display limits the connectivity map to emphasize switch members only.
Displaying end nodes
To display end nodes when discovering a new fabric, complete the following steps.
1. Select Server > Options.
The Options dialog box displays ( Figure 23 ).
FIGURE 23
Options dialog box (SAN End Node Display pane)
2. Select SAN End Node Display in the Category list.
3. Select the Show connected end nodes when new fabric is discovered check box to display end
nodes on your system.
NOTE
Before changes can take effect, the topology must be rediscovered.
4. Click Apply or OK to save your work.