Boston Whaler 37 Justice Series, Operation & Maintenance Manual

Page: 191 / 214

6-13
Maintenance Section 6
Check the operation of the steering system before each
mission. Turn the steering wheel from hard port to hard
starboard while watching the engines for any unusual
movement. If any unusual movement is detected, have
the steering system serviced before operating the boat. It
is good boating practice to rinse off your steering cylinder
thoroughly with fresh, clean water after each use.
Every si months, a qualified marine technician should
check the following items in addition to the specific
manufacturer requirements:
Check the uid level in the helm pump unit.
Check outboard engine tilt tube for salt deposits or
signs of corrosion. Clean and grease as required.
Check and grease slider assembly on front of the
engine steering cylinder assemblies.
Check mechanical linkage and connections.
Check all fasteners and the complete steering system
for security and integrity.
Inspect for corrosion. Any part affected by corrosion
must be replaced.
Tighten loose parts and replace any worn items.
When replacing parts, self locking hardware must be
used.
Check all self locking fasteners and locking tabs for
tightness.
Check system for hydraulic uid leaks. Refill and
purge system as necessary.
Check steering hoses for signs of chafing, cuts, and
leaks. Replace any steering hose that shows signs
of damage.
Inspect the bilge, console interior, and splashwell for
signs of leaking hydraulic uid.