(2)
To prevent devices interfering with each other, do not install the device close to elec-
tronic devices such as hi-fi systems, office equipment or microwave ovens. Neither
should you install it near heat sources such as radiators, or in damp rooms.
(3)
Comply with the gaps as indicated at the bottom in the picture.
Fig. 14: Drilling template
(4)
Mark the drilling holes in the wall.
(5)
Check that all the points where the hybird 120 / hybird 130 is attached to the wall
can bear its weight. Ensure that there are no utility lines, cables etc. located in the
area where the holes are marked.
(6)
Drill the holes at the points marked (if inserting into rawlplugs, use a 5 mm masonry
drill). Insert the rawlplug.
(7)
Screw the top two screws in such a way that there is still a gap of about 5 mm
between the screw head and the wall.
(8)
Open the device by carefully removing the faceplate.
(9)
Hang the hybird 120 / hybird 130 with the rear brackets from above behind the screw
heads.
(10) Screw the lower screws through the device so that it is fixed firmly to the wall.
(11) If necessary, install the sockets for the terminals. Connect the socket installation to
that of the device. The sockets are used for a permanent installation, for example in a
hallway. When they are installed, the connecting cables are connected to the connect-
ors on the device,
(12) Plug the connectors on the device into the sockets.
3 Installation
bintec elmeg GmbH
32
elmeg hybird 120 / hybird 130
