19.4.4 Neighbor APs
Fig. 163:
Wireless LAN Controller
->
Monitoring
->
Neighbor APs
In the Wireless LAN Controller->Monitoring->Neighbor APs menu, the adjacent AP's
found during the scan are displayed. Rogue APs, i.e. APs which are not managed by the
WLAN controller but are using an SSID managed by the WLAN controller are highlighted in
red.
Note
Check the rogue APs shown carefully, as an attacker could attempt to spy on data in
your network using a rogue AP.
Although each AP is found more than once, it is only displayed once with the strongest sig-
nal. You see the following parameters for each AP: SSID, MAC Address, Signal dBm,
Channel, Security, Last seen, Strongest signal received by , Total detections.
The entries are displayed in alphabetical order by SSID. Security shows the security set-
tings of the AP. Under Strongest signal received by, you will see the parameters Loca-
tion and Name of the APs in which the displayed AP was found. Total detections shows
how often the corresponding AP was found during the scan.
Click under New Neighborscan on Start, to rescan adjacent AP's. You will receive a warn-
ing that the wireless modules of the access points must also be disabled for a certain peri-
od of time. When you start the process with OK, a progress bar is displayed. The located
AP display is updated every ten seconds.
19 Wireless LAN Controller
bintec elmeg GmbH
364
elmeg hybird 120 / hybird 130
