AVT Titan, Operator'S Manual

Page: 70 / 202

3 – 7 0 040 7448 329657 (04.97) PC-SW 4.5
C H A P T E R 3 : O P E R A T I O N W I T H A P C
PIP POSITION
This switch controls the position of the PIP. The possible positions are shown
below:
TABLE 3.4 SELECTION POSSIBILITIES FOR PIP AND BACKGROUND PICTURE
BACKGROUND
Either the output of the motion video codec (VIDEO) or the output of the gra-
phics codec (see TABLE 3.4) can be used as the background for the PIP. With
the slide selector, select the video picture for the background. If you require
the output of the motion video codec as preview, you can switch the input si-
gnal through to the output. This takes place in the Video Interfaces menu. In
this setting, the motion video codec is bypassed and therefore no PIP can be
inserted (see TABLE 3.4).
PIP: Selecting the PIP source
The following signals can be used as the PIP source (see also TABLE 3.4):
Click CLOSE to exit the window.
3.3.6.1.2 CAMERA CONTROL
If the CAMERA CONTROL key is pressed, a panel is called up with which a
connected camera can be controlled. The functions provided here can be
used to control a 680D Vidimech or Canon VC-C1 pan + tilt head. Control is
by commands at the RS485 interface.
Background PIP
Received picture
Own (local) picture
Received (remote) picture
Graphics picture
Graphics picture
Own picture
Received picture
Graphics picture
Preview –
a
a In this mode, the motion video codec is bypassed. A PIP can therefore not be inserted.
Setting Meaning
INCOMING MOTION VIDEO Received motion video from partner (far end)
GRAPHIC Picture of the JPEG Graphics Codec
OUTGOING MOTION VIDEO Motion video codec output (picture from local end)
OFF PIP switched off
2+2 0QTVJ 9GUV
2+2 5QWVJ 9GUV
2+2 0QTVJ 'CUV
2+2 5QWVJ 'CUV
%#/'4# %10641.