AVT Titan, Operator'S Manual

Page: 38 / 202

2 – 3 8 040 7448 329657 (04.97) PC-SW 4.5
C H A P T E R 2 : P U T T I N G T H E S Y S T E M I N T O O P E R A T I O N
Select the required adapter from the list and confirm with the Enter key.
The program now enquires what monitor has been connected. If you are using
a colour monitor, press the letter “c”. If you are using a monochrome monitor
in combination with a colour graphics board, it is possible that some colour
combinations will lead to unreadable menus. In this case enter “m” to ensure
that all menus are readable.
The adaptation of the software to your graphics board is now completed.
Note If the fault message “Can’t find main.uir” or similar appears
when the program is started, then it is very likely that the wrong
adapter has been installed.
2.13.5 Selection of the PC interface
To select the PC interface, a parameter is entered after the program name TI-
TAN during the calling up of the program
1
.
TITAN /1
starts the software with the COM1 interface
TITAN /2
starts the software with the COM2 interface
The installation and configuration of the software is now completed.
1 If a parameter is not entered, the COM1 interface is selected by default.