AVT Titan, Operator'S Manual

Page: 115 / 202

5 – 1 2 1 040 7448 329657 (04.97) PC-SW 4.5
C H A P T E R 5 : C O M M A N D S
CON(NECT)
Description: The CONNECT command is used to set up connections with
the X.21 interfaces. The call numbers are transferred only in
Mode 2 (see SECTION 1.5.3.1). The codec sets up this con-
nection via the X.21 interfaces. Depending on the number of
calling numbers, the connections are set up one after the other.
If connection no. 3 is not possible, for example, a connection
with the first 2 channels is used.
The CONNECT command (without parameters) is also used
for all other network interfaces to confirm the beginning of a
conference.
Command: ^B CON / [[[[[[Parameter 1] Parameter 2] Parameter 3]
Parameter 4] Parameter 5]Parameter 6]<cr>
Response: ^P CON <cr>
- Command executed -
^P CON <^N> 1 <^N> 1 <cr>
- Syntax error -
^P CON <^N> 1 <^N> 2 <cr>
- Command not executable -
Parameter 1: Calling number 1 of the far end (if required)
Parameter 2: Calling number 2 of the far end (if required)
Parameter 3: Calling number 3 of the far end (if required)
Parameter 4: Calling number 4 of the far end (if required)
Parameter 5: Calling number 5 of the far end (if required)
Parameter 6: Calling number 6 of the far end (if required)
Note: The RATE command can be used to poll the data rate. Informa-
tion is given on how many connections have been provided by
the public network.
CUR(SOR)
Description: The CURSOR command switches the local graphics cursor on
or off. This command is only available in combination with the
Graphics option. The graphics cursor of the far end can only be
switched on or off from the far end.
Command: ^B CUR / Parameter 1<cr>
Response: ^P CUR <cr>
- Command executed -
^P CUR <^N> 1 <^N> 1 <cr>
- Syntax error -
^P CUR <^N> 1 <^N> 2 <cr>
- Command not executable -
Parameter 1: Selects the cursor status
ON switches the own (local) graphics cursor on
OFF switches the own (local) graphics cursor off
TOG Toggles the current status of the cursor