AudioCodes Mediant 500 MSBR, User Manual

Page: 681 / 1248

Version 7.2 681 Mediant 500 MSBR
User's Manual 37. Routing SBC
is not registered, the call is rejected.

[11] IP Group Set = The device employs load balancing and routes
the call to one of the IP Groups in the IP Group Set assigned using
the 'IP Group Set' parameter (below).

[12] Destination Tag = The device routes the call to an IP Group
determined by Dial Plan tags. The tag is specified in the 'Routing
Tag Name' parameter (below). For more information on using tags to
determine destination IP Group, see Using Dial Plan Tags for
Routing Destinations on page 720.

[13] Internal = Instead of sending the incoming SIP dialog to another
destination, the device replies to the sender of the dialog with a SIP
response code or a redirection response, configured by the 'Internal
Action' (IP2IPRouting_InternalAction) parameter in this table (see
below).
Note: Use option [5] Dial Plan only for backward compatibility
purposes; otherwise, use prefix tags as described in Configuring Dial
Plans on page 711.
Destination IP Group
dst-ip-group-name
[IP2IPRouting_DestIPGro
upName]
Defines the IP Group to where you want to route the call. The actual
destination of the SIP dialog message depends on the IP Group type
(as defined in the 'Type' parameter):

Server-type IP Group: The SIP dialog is sent to the IP address
configured for the Proxy Set that is associated with the IP Group.

User-type IP Group: The device checks if the SIP dialog is from a
registered user, by searching for a match between the Request-URI
of the received SIP dialog and an AOR registration record in the
device's database. If found, the device sends the SIP dialog to the IP
address specified in the database for the registered contact.
By default, no value is defined.
Note:

The parameter is applicable only if the 'Destination Type' parameter
is configured to
IP Group .

The selectable IP Group for the parameter depends on the assigned
Routing Policy (in the 'Routing Policy' parameter in this table). For
more information, see Configuring SBC Routing Policy Rules on
page 692.
Destination SIP Interface
dest-sip-interface-
name
[IP2IPRouting_DestSIPInt
erfaceName]
Defines the destination SIP Interface to where the call is sent.
By default, no value is defined.
To configure SIP Interfaces, see Configuring SIP Interfaces on page
325.
Note:

The parameter is applicable only if the 'Destination Type' parameter
is configured to any value other than IP Group . If the 'Destination
Type' parameter is configured to IP Group , the following SIP
Interface is used:

Server-type IP Groups: SIP Interface that is assigned to the
Proxy Set associated with the IP Group.

User-type IP Groups: SIP Interface is determined during user
registration with the device.

For multi-tenancy, if the assigned Routing Policy is not shared (i.e.,
the Routing Policy is associated with an Isolated SRD), the SIP
Interface must be one that is associated with the Routing Policy or
with a shared Routing Policy (i.e., the Routing Policy is associated
with one or more Shared SRDs). If the Routing Policy is shared, the