AudioCodes Mediant 500 MSBR, User Manual

Page: 963 / 1248

Version 7.2 963 Mediant 500 MSBR
User's Manual 69. Testing SIP Signaling Calls
Test Mode
test-mode
[Test_Call_TestMod
e]
Defines the test session mode.

[0] Once = (Default) The test runs until the lowest value between the
following is reached:

Maximum channels is reached for the test session, configured by
'Maximum Channels for Session'.

Call duration ('Call Duration') multiplied by calls per second ('Calls
per Second').

Test duration expires, configured by 'Test Duration'.

[1] Continuous = The test runs until the configured test duration is
reached. If it reaches the maximum channels configured for the test
session (in the 'Maximum Channels for Session'), it waits until the
configured call duration of a currently established tested call expires
before making the next test call. In this way, the test session stays within
the configured maximum channels.
Note: The parameter is applicable only if you configure 'Call Party' to
Caller .
Test Duration
test-duration
[Test_Call_TestDura
tion]
Defines the test duration (in minutes).
The valid value is 0 to 100000. The default is 0 (i.e., unlimited).
Note: The parameter is applicable only if you configure 'Call Party' to
Caller .
Play
play
[Test_Call_Play]
Enables and defines the playing of a tone to the answered side of the call.

[0] Disable

[1] DTMF = (Default) Plays a user-defined DTMF string, configured in
Configuring DTMF Tones for Test Calls on page 966.

[2] PRT = Plays a non-DTMF tone from the PRT file (Test Call Tone).
For this option, you must load a PRT file to the device (see Prerecorded
Tones File on page 778).
Note:


To configure the DTMF signaling type (e.g., out-of-band or in-band) use
the 'DTMF Transport Type' parameter (see Configuring DTMF Transport
Types on page 181).

The parameter is applicable only if you configure 'Call Party' to Caller .

Schedule Interval
schedule-interval
[Test_Call_Schedule
Interval]
Defines the interval (in minutes) between automatic outgoing test calls.
The valid value range is 0 to 100000. The default is 0 (i.e., scheduling is
disabled).
Note: The parameter is applicable only if you configure 'Call Party' to
Caller .
69.2 Starting and Stopping Test Calls
The following procedure describes how to start, stop, and restart test calls.

To start, stop, and restart a test call:
1. In the Test Call Rules table, select the required test call entry.
2. From the Action drop-down list, choose the required command:
•
Dial: Starts the test call (applicable only if the test call party is the caller).