AudioCodes Mediant 500 MSBR, User Manual

Page: 343 / 1248

Version 7.2 343 Mediant 500 MSBR
User's Manual 20. Control Network
message is used as the destination port.
DTLS Context
dtls-context
[IPGroup_DTLSContext]
Assigns a TLS Context (certificate) to the IP Group, which is used for
DTLS sessions (handshakes) with the IP Group.
By default, no value is defined.
To configure TLS Contexts, see Configuring TLS Certificate Contexts on
page 117.
Keep Original Call-ID
sbc-keep-call-id
[IPGroup_SBCKeepOrigin
alCallID]
Enables the device to use the same call identification (SIP Call-ID
header value) received in incoming messages for the call identification in
outgoing messages. The call identification value is contained in the SIP
Call-ID header.

[0] No = (Default) The device creates a new Call-ID value for the
outgoing message.

[1] Yes = The device uses the same Call-ID value received in the
incoming message for the Call-ID in the outgoing message.
Note: When the device sends an INVITE as a result of a REFER/3xx
termination, the device always creates a new Call-ID value and ignores
the parameter's settings.
Dial Plan
sbc-dial-plan-name
[IPGroup_SBCDialPlanNa
me]
Assigns a Dial Plan to the IP Group. The device searches the Dial Plan
for a dial plan rule that matches the prefix of the source number and if
not found, for a rule that matches the prefix of the destination number. If
a matching dial plan rule is found, the rule's tag is used in the routing
and/or manipulation processes as source and/or destination tags.
To configure Dial Plans, see Configuring Dial Plans on page 711.
Note: For IP-to-IP Routing rules that are configured for destination
based on tags (i.e., 'Destination Type' parameter configured to
Destination Tag), the parameter is applicable only to the source IP
Group and the device searches the Dial Plan for a dial plan rule that
matches the prefix of the destination number only. For more information
on routing based on destination tags, see Using Dial Plan Tags for
Routing Destinations on page 720.
Tags
tags
[IPGroup_Tags]
Assigns a Dial Plan tag that is used to determine whether the incoming
SIP dialog is sent to this IP Group. The parameter is used when IP-to-IP
Routing rules are configured for destination based on tags (i.e.,
'Destination Type' parameter configured to Destination Tag). For more
information on routing based on destination tags, see Using Dial Plan
Tags for Routing Destinations on page 720.
Call Setup Rules Set ID
call-setup-rules-set-id
[IPGroup_CallSetupRules
SetId]
Assigns a Call Setup Rule Set ID to the IP Group. The device runs the
Call Setup rule immediately before the routing stage (i.e., only after the
classification and manipulation stages).
By default, no value is assigned.
To configure Call Setup Rules, see Configuring Call Setup Rules on
page 372.
Quality of Experience
QoE Profile
qoe-profile
[IPGroup_QOEProfile]
Assigns a Quality of Experience Profile rule.
By default, no value is defined.
To configure Quality of Experience Profiles, see Configuring Quality of
Experience Profiles on page 293.