AudioCodes Mediant 500 MSBR, User Manual

Page: 1027 / 1248

Version 7.2 1027 Mediant 500 MSBR
User's Manual 74. Configuration Parameters Reference
Public Key
configure system > cli-
settings > ssh-require-
public-key
[SSHRequirePublicKey]
Enables RSA public keys for SSH.

[0] Disable = (Default) RSA public keys are optional if a public key is
configured (see the SSHAdminKey parameter or Local Users table).

[1] Enable = RSA public keys are mandatory.
Note: To define the key size, use the TLSPkeySize parameter.
Max Payload Size
ssh-max-payload-size
[SSHMaxPayloadSize]
Defines the maximum uncompressed payload size (in bytes) for SSH
packets.
The valid value is 550 to 32768. The default is 32768.
Max Binary Packet Size
configure system > cli-
settings > ssh-max-
binary-packet-size
[SSHMaxBinaryPacketSi
ze]
Defines the maximum packet size (in bytes) for SSH packets.
The valid value is 582 to 35000. The default is 35000.
Maximum SSH Sessions
configure system > cli-
settings > ssh-max-
sessions
[SSHMaxSessions]
Defines the maximum number of simultaneous SSH sessions.
The valid range is 1 to 5. The default is 5.
Enable Last Login
Message
configure system > cli-
settings > ssh-last-login-
message
[SSHEnableLastLoginMe
ssage]
Enables message display in SSH sessions of the time and date of the
last SSH login. The SSH login message displays the number of
unsuccessful login attempts since the last successful login.

[0] Disable

[1] Enable (default)
Note: The last SSH login information is cleared when the device is reset.
Max Login Attempts
configure system > cli-
settings > ssh-max-login-
attempts
[SSHMaxLoginAttempt
s]
Defines the maximum SSH login attempts allowed for entering an
incorrect password by an administrator before the SSH session is
rejected.
The valid range is 1 to 5. The default is 3.
Note: The new setting takes effect only for new subsequent SSH
connections.
74.4.6 TAACS+ Parameters
The parameters are described in the table below.
Table 74-27: Parameters
Parameter Description
aaa authentication login
[TacPlusEnable]
Enables the Terminal Access Controller Access-Control System
() remote authentication protocol and user authentication for
CLI login.

[0] = Disabled (default)

[1] = Enabled
Note: For the parameter to take effect, a device reset is required.