AudioCodes Mediant 500 MSBR, User Manual

Page: 76 / 1248

User's Manual 76 Document #: LTRT-10375
Mediant 500 MSBR
Session Limit
session-limit
[WebUsers_SessionLimit]
Defines the maximum number of concurrent Web interface sessions
allowed for the specific user. For example, if configured to 2, the same
user account can be logged into the device’s Web interface (i.e.,
same username-password combination) from two different
management stations (i.e., IP addresses) at any one time. Once the
user logs in, the session is active until the user logs off (by clicking the
Log off icon on the toolbar) or until the session expires if the user is
inactive for a user-defined duration (see the 'Session Timeout'
parameter below).
The valid value is 0 to 5. The default is 2.
Note: Up to five users can be concurrently logged in to the Web
interface.
Session Timeout
session-timeout
[WebUsers_SessionTimeo
ut]
Defines the duration (in minutes) of inactivity of a logged-in user in the
Web interface, after which the user is automatically logged off the
Web session. In other words, the session expires when the user has
not performed any operations (activities) in the Web interface for the
configured timeout duration.
The valid value is 0 to 100000. A value of 0 means no timeout. The
default value is according to the settings of the WebSessionTimeout
global parameter (see Configuring Web Session and Access Settings
on page 77).
Block Duration
block-duration
[WebUsers_BlockTime]
Defines the duration (in seconds) for which the user is blocked when
the user exceeds a user-defined number of failed login attempts.
The valid value is 0 to 100000, where 0 means that the user can do
as many login failures without getting blocked. The default is
according to the settings of the 'Deny Authentication Timer' parameter
(see Configuring Web Session and Access Settings on page 77).
Note:

To enable this feature, see the 'Deny Access On Fail Count'
parameter in Configuring Web Session and Access Settings on
page 77.

The 'Deny Authentication Timer' parameter relates to failed Web
logins from specific IP addresses.
7.4 Displaying Login Information upon Login
You can enable the device to display login information immediately upon Web login.

To enable display of user login information upon login:
1. Open the Web Settings page ( Setup menu > Administration tab > Web & CLI folder
> Web Settings ).
2. Under the Security group, from the 'Display Last Login Information' drop-down list,
select Enable .
3. Click Apply .