AudioCodes Mediant 500 MSBR, User Manual

Page: 961 / 1248

Version 7.2 961 Mediant 500 MSBR
User's Manual 69. Testing SIP Signaling Calls
Route By
route-by
[Test_Call_RouteBy]
Defines the type of routing method. This applies to incoming and outgoing
calls.

[0] Tel-to-IP = Calls are matched by a Tel-to-IP routing rule in the Tel-to-
IP Routing table (see Configuring Tel-to-IP Routing Rules on page 495).

[1] IP Group = (Default) Calls are matched by (or routed to) an IP Group.
To specify the IP Group, see the 'IP Group' parameter in the table.

[2] Dest Address = Calls are matched by (or routed to) a destination IP
address. To configure the address, see the 'Destination Address'
parameter in the table.
Note:

If configured to Tel-to-IP or Dest Address , you must assign a SIP
Interface (see the 'SIP Interface' parameter in the table).

For REGISTER messages:

The Tel-to-IP option cannot be used as the routing method.

If configured to IP Group, only Server-type IP Groups can be used.
IP Group
ip-group-id
[Test_Call_IPGroup
Name]
Assigns an IP Group. This is the IP Group that the test call is sent to or
received from.
By default, no value is defined.
To configure IP Groups, see Configuring IP Groups on page 333.
Note:

The parameter is applicable only if you configure the 'Route By'
parameter to
IP Group .

The IP Group is used for incoming and outgoing calls.
Destination Address
dst-address
[Test_Call_DestAddr
ess]
Defines the destination host.
The valid value is an IP address[:port] or DNS name[:port].
Note: The parameter is applicable only if the 'Route By' parameter is
configured to Dest Address [2].
SIP Interface
sip-interface-name
[Test_Call_SIPInterf
aceName]
Assigns a SIP Interface. This is the SIP Interface to which the test call is
sent and received from.
By default, no value is defined.
To configure SIP Interfaces, see Configuring SIP Interfaces on page 325.
Note: The parameter is applicable only if the 'Route By' parameter is
configured to Tel-to-IP or Dest Address.
Application Type
application-type
[Test_Call_Applicatio
nType]
Defines the application type for the endpoint. This associates the IP Group
and SRD to a specific SIP interface. For example, assume two SIP
Interfaces are configured in the SIP Interfaces table where one is set to
"GW" and one to "SBC" for the 'Application Type'. If the parameter is set to
"SBC", the device uses the SIP Interface set to "SBC".

[0] GW = (Default) Gateway application

[2] SBC = SBC application
Destination
Transport Type
dst-transport
[Test_Call_DestTran
sportType]
Defines the transport type for outgoing calls.

[-1] = Not configured (default)

[0] UDP

[1] TCP

[2] TLS
Note: The parameter is applicable only if the 'Route By' parameter is set to
Dest Address .