AudioCodes Mediant 500 MSBR, User Manual

Page: 375 / 1248

Version 7.2 375 Mediant 500 MSBR
User's Manual 21. SIP Definitions
Parameter Description
e] LDAP server.

[2] Dial Plan = The Call Setup rule performs a query with the Dial
Plan.
To specify an LDAP server or Dial Plan, use the 'Query Target'
parameter (see below).
Query Target
query-target
[CallSetupRules_QueryTar
get]
Defines one of the following, depending on the value configured for the
'Query Type' parameter (above).

LDAP: Specifies an LDAP server (LDAP Server Group) on which to
perform an LDAP query for a defined search key. To configure
LDAP Server Groups, see Configuring LDAP Server Groups on
page 218.

Dial Plan: Specifies a Dial Plan (name) in which to search for a
defined search key. To configure Dial Plans, see Configuring Dial
Plans on page 711.
To configure the search key, use the 'Search Key' parameter (see
below).
Note: The parameter is applicable only if the 'Query Type' parameter is
configured to any value other than None .
Search Key
attr-to-query
[CallSetupRules_Attributes
ToQuery]
Defines the key to query. For LDAP queries, the key string is queried in
the specified LDAP server. For Dial Plan queries, the key string is
searched for in the specified Dial Plan.
The valid value is a string of up to 100 characters. Combined strings
and values can be configured like in the Message Manipulations table,
using the '+' operator. Single quotes (') can be used for specifying a
constant string (e.g., '12345').
Examples:

To LDAP query the AD attribute "mobile" that has the value of the
destination user part of the incoming call:
'mobile=' + param.call.dst.user

To LDAP query the AD attribute "telephoneNumber" that has a
redirect number:
'telephoneNumber=' + param.call.re '*'

To query a Dial Plan for the source number:
param.call.src.user
Note: The parameter is applicable only if the 'Query Type' parameter is
configured to any value other than None .
Attributes To Get
attr-to-get
[CallSetupRules_Attributes
ToGet]
Defines the Attributes of the queried LDAP record that the device must
handle (e.g., retrieve value).
The valid value is a string of up to 100 characters. Up to five attributes
can be defined, each separated by a comma (e.g., msRTCSIP-
PrivateLine,msRTCSIP-Line,mobile).
Note:

The parameter is applicable only if you configure the 'Query Type'
parameter to
LDAP .

The device saves the retrieved attributes' values for future use in
other rules until the next LDAP query or until the call is connected.
Thus, the device does not need to re-query the same attributes.
Row Role Determines which condition must be met in order for this rule to be
performed.