1 947997
ISSUE 4
VIP-814
QUAD NETWORKED STATION PORT
INTRODUCTION
The VIP-814 Quad Networked Station Port
allows most loop start terminal devices to be
connected to a managed IP-based LAN/WAN.
SPECIFICATIONS
Access Methods
PBX, FXO Port
POTS telephone set
Features
RJ-45 for network connection
4 RJ-11 telephone connections
4 Relays with Form C contacts
Generates Caller ID Signals
Front panel activity LED
Network activity LEDs
2 REN
2.5mm jack for DC
802.3af compliant
Dimensions/Weight
1.75 H x 6.75" W x 9.5" D
(4.45cm H x 17.15cm W x 24.13cm D)
Weight: 1.75 lbs. (0.80 kg)
Nominal Specifications
Input Impedance:
600 Ohms
Input Level:
-10dBm
Output Impedance:
600 Ohms
Output Level:
- 10dBm nominal
Relay Current:
1 AMP @ 24VDC
Nominal Power Requirements
Via rear panel barrel connector:
Voltage:
24VDC
Current:
325mA
Via 802.3af PoE Ethernet Switch:
802.3af:
Class 3
Environment
Temperature:
0 to +40° C
Humidity:
0 to 85% non-precipitating
Packing List
Qty
Item
1
VIP-814
1
VIP Setup CD
1
VSP Document
2
Mounting Brackets
4
Rubber Pads
6
Wood Screws
1
RJ-45 Patch Cable
INSTALLATION
NOTE: The telephone system referred to in
this manual is the customer premise
equipment such as an electronic key system,
a PBX or a dedicated single line telephone
sets. The VIP-814 is not intended for direct
or indirect connection to the public
telephone network. When used with a
customer premise telephone system such as
a key system or PBX system, these units are
interfaced to the system via a fully protected
page port or system central office port,
which is a fully protected interface device.
Also, the host system must be configured to
disallow central office trunk conferencing in
order to prevent indirect connection to the
public network.
