AudioCodes Mediant 500 MSBR, User Manual

Page: 266 / 1248

User's Manual 266 Document #: LTRT-10375
Mediant 500 MSBR
Listening Interface
listening-int
[HTTPProxyService_Listen
ingInterface]
Assigns an HTTP Interface to the HTTP Proxy service. To configure
HTTP Interfaces, see Configuring HTTP Interfaces on page 263.
Note: The parameter is mandatory.
URL Prefix
url-prefix
[HTTPProxyService_URLP
refix]
Defines the URL prefix that is used to access the managed
equipment's embedded Web server. The URL prefix is matched
against the target of the HTTP requests sent by the client (such as
GET and POST). If a match is located in the table, the device removes
the prefix from the request and then forwards the HTTP request to the
managed equipment without the prefix. For example, for the URL of
GET /home/index.html HTTP/1.1 (which is part of the URL
http://10.20.30.40/home/index.html), a URL prefix of “/home” can be
configured. To match all URLs, configure the parameter to "/" (default).
Keep-Alive Mode
keep-alive-mode
[HTTPProxyService_Keep
AliveMode]
Enables a keep-alive mechanism with the managed equipment:

[0] Disable

[1] Options = (Default) Enables keep-alive by sending HTTP
OPTIONS messages. If no response is received from the HTTP
host, the device stops forwarding HTTP requests to the host and
raises an SNMP alarm (acHTTPProxyServiceAlarm). If you
configured the address of the host as an FQDN (see Configuring
HTTP Proxy Hosts on page 266) and the DNS resolution results in
multiple IP addresses, when no response is received from the keep-
alive, the device checks connectivity with the next resolved IP
address and so on, until a response is received.
18.6.4.1 Configuring HTTP Proxy Hosts
The HTTP Proxy Hosts table lets you configure HTTP Proxy hosts for HTTP Proxy
services. An HTTP Proxy Host represents the HTTP-based managed equipment (e.g., IP
Phone). The table is a "child" of the HTTP Proxy Services table (see Configuring HTTP
Proxy Services on page 265). You can configure up to 50 HTTP Proxy hosts; up to 5 HTTP
Proxy hosts per HTTP Proxy Service.
The following procedure describes how to configure HTTP Remote hosts through the Web
interface. You can also configure it through ini file (HTTPProxyHost) or CLI (configure
network > http-proxy http-proxy-host).

To configure an HTTP Proxy Host:
1. Open the HTTP Proxy Services table ( Setup menu > IP Network tab > HTTP Proxy
folder > HTTP Proxy Services ).
2. In the table, select the required HTTP Proxy Service index row, and then click the
HTTP Proxy Hosts link located below the table; the HTTP Proxy Hosts table appears.