AudioCodes Mediant 500 MSBR, User Manual

Page: 1186 / 1248

User's Manual 1186 Document #: LTRT-10375
Mediant 500 MSBR
[TrunkGroupSettings] FORMAT TrunkGroupSettings_Index =
TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode,
TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName,
TrunkGroupSettings_ContactUser,
TrunkGroupSettings_ServingIPGroupName,
TrunkGroupSettings_MWIInterrogationType,
TrunkGroupSettings_TrunkGroupName,
TrunkGroupSettings_UsedByRoutingServer;
[\TrunkGroupSettings]
For more information, see Configuring Trunk Group Settings on
page 487.
Channel Select Mode
ch-select-mode
[ChannelSelectMode]
Defines the method for allocating incoming IP-to-Tel calls to a
channel. The parameter applies to the following:

All Trunk Groups configured without a channel select mode in
the Trunk Group Settings table (see Configuring Trunk Group
Settings on page 487).

All channels and trunks configured without a Trunk Group ID.
for all Trunk Groups channels that are configured without a Trunk
Group ID,.

[0] By Dest Phone Number

[1] Cyclic Ascending (default)

[2] Ascending

[3] Cyclic Descending

[4] Descending

[5] Dest Cyclic Ascending.

[6] By Source Phone Number

[7] Trunk Cyclic Ascending

[8] Trunk & Channel Cyclic Ascending

[9] Ring to Hunt Group

[10] Select Trunk By Supplementary Service Table

[11] Dest Ascending
For a detailed description of the parameter's options, see
Configuring Trunk Group Settings on page 487.
Default Destination Number
configure voip > gateway
dtmf-supp-service dtmf-and-
dialing > ddflt-dest-nb
[DefaultNumber]
Defines the default destination phone number, which is used if the
received message doesn't contain a called party number and no
phone number is configured in the Trunk Group table (see
Configuring the Trunk Groups on page 485). The parameter is
used as a starting number for the list of channels comprising all the
device's Trunk Groups.
The default is 1000.
Source IP Address Input
configure voip > gateway
routing settings > src-ip-addr-
input
[SourceIPAddressInput]
Determines which IP address the device uses to determine the
source of incoming INVITE messages for IP-to-Tel routing.

[-1] = (Default) Auto Decision - the parameter is automatically
set to SIP Contact Header (1).

[0] SIP Contact Header = The IP address in the Contact header
of the incoming INVITE message is used.

[1] Layer 3 Source IP = The actual IP address (Layer 3) from
where the SIP packet was received is used.
Use Source Number As
Display Name Determines the use of Tel Source Number and Display Name for
Tel-to-IP calls.