3-8
CHP Max™ Headend Optics Platform Chassis, Controllers and Power Supplies
Rev D
Functional Description
Figure 3.4
CHP Max5000
System Block
Diagram
DC Voltages
The CHP Max power supply feeds DC voltages into the backplane through a multi-pin
DC/Communications connector. These voltages travel along the DC power bus, entering each
application module through multi-pin DC/Communications Interfaces.
Management Signals
Local Monitoring
Craft Management Software
is used to monitor a single CHP Max5000 chassis through a direct
RS-232 connection to the CMM or SMM. The CMM or SMM sends management signals
through the SPI bus on the chassis backplane to the other modules installed in the chassis,
and status information from the modules travels back through the same route; the CMM or
SMM then communicates with the computer running the
Craft Management Software
.
Shelf
Interconnect
SNMP
Ethernet
Local
Alarm Com
N. O.
N. C.
Chassis Fan
(1 of 8
shown)
Aux Backplane
Main Backplane
Application Module 1
Application Module 2
Application Module
10
Power Supply 1
Power Supply 2
Management Module
(CMM or SMM)
Po
we
r
B
u
s
Fan
C
urrent
sense
SPI
Bu
s
RS-485
Module
Select
Lines
(12)
DC/Communications Interfaces
Please note that the contacts on the Local Alarm terminal block are reversed.
Summary of Contents for CHP Max5000
