Rev D
CHP Max5000 Chassis (Front Fiber Version)
3-3
Unpacking
All units are tested and inspected before shipment and found to be free of mechanical and
electrical defects. However, upon receiving your product:
1. Examine all shipping containers for any damage due to transit.
2. Unpack all modules and chassis.
3. Keep all packing materials until your inspection is complete. When possible, save the
shipping container for future reshipment and/or storage.
If damage is discovered, file a claim with the carrier immediately and notify your ARRIS
representative as soon as possible. Product deemed defective by the original purchaser must
be returned to ARRIS prepaid in the original packing material (or equivalent) with a Return
Material Authorization (RMA) from ARRIS Customer Service.
Precautions
Failure to comply with these general safety precautions and with the specific precautions
described elsewhere in this manual violates the safety standards of the design, manufacture,
and intended use of the device. C-COR assumes no liability for the customer’s failure to
comply with these precautions.
Table 3.2 Tools and Materials
Tools/Materials
Required Specifications
Uses
Phillips screwdriver
#2
Chassis installation
ESD grounding strap
N/A
Handling SMM, CMM, and
application modules.
Note
For best performance, ARRIS recommends daisy-chaining a maximum of 5
chassis together; 6 to 10 may be daisy-chained together, but it will impact
performance.
CAUTION
Do not operate the chassis and installed modules in an ambient
environment above 50º C (122º F) or below 0° C (32° F) or with noncondensing
relative humidity above 90% or below 10%. Doing so may result in unsatisfactory
performance, unit failure, shortened unit life span, or a safety hazard.
CAUTION
Do not attempt to modify or service any part of this chassis not
specifically referred to as replaceable in this manual. Doing so voids the warranty.
Return the chassis to ARRIS for service and repair.
CAUTION
Store the chassis and modules away from corrosive materials at a
temperature between –40 and 70º C (–40 and 158º F) and with no more than 90%
humidity, noncondensing.
Summary of Contents for CHP Max5000
