Rev D
System Management Module 2 (SMM-2)
7-29
3. Press the
Enter
key after the all of the network information is complete
For example,
set interfaces eth0 10.113.130.110 mask 255.255.255.0
gateway 10.113.130.254
would be a complete entry, whereas just
set interfaces
eth0 10.113.130.110
would not be a complete entry.
4. At the [email protected]% prompt, type
commit
and press the
Enter
key. The
SMM-2 will log you off the system and when you log back on, the
[email protected] > prompt will reflect the new IPv4 address of the SMM-2.
Serial Port Mode
Windows 7 Gadget Serial Driver Installation
In some versions of Windows 7, the Gadget Serial driver gets installed automatically when
the USB serial cable is connected to the SMM-2. To verify this, check to see if Control
Panel>Device Manger>Ports (COM & LPT)>Gadget Serial (COM#) is loaded.
In other versions of Windows 7, when the USB serial cable is connected to the SMM-2, you
may see a message "Device driver software was not successfully installed" which will require
a manual installation of the Gadget Serial driver.
Follow these steps to install the Gadget Serial driver:
1. The
usbser.sys
file is archived at different locations depending on the operating
system (32-bit or 64-bit). As administrator, search for
usbser.sys
on the local C:\ drive.
For a 32-bit Intel machine
usbser.sys
may be located at
C:\Windows\System32\DriverStore\FileRepository\mdmcpq.inf_x86_neutral_9f203c20
b6f0dabd
For a 64-bit AMD machine, usbser.sys may be located at
C:\Windows\System32\DriverStore\FileRepository\mdmcpq.inf_amd64_neutral_77452
3d133de6343
2. To search and find the
usbser.sys
file:
a. Open Windows Explorer and begin searching for
usbser.sys
from
C:\Windows\System32\.
b. Select
usbser.sys
and right-click: Open file location.
c. Copy the
usbser.sys
file to the destination folder location as
C:\Windows\System32\drivers
.
SMM-2 Serial Mode Configuration
To change the USB connection mode to serial:
1. Connect and log onto the SMM-2, then enter configuration mode by typing
configure
and pressing the
Enter
key.
2. At the command prompt, type
set CHPMAX5000-MIB chpMaxShelves chpUsbMode
serial
.
Note
The SMM2 USB Serial driver which is distributed on the CHP System Release
CD is very specific to Windows XP. The file
gserial.inf
is not needed on Windows 7.
Summary of Contents for CHP Max5000
