Angelo Po FX Series, Technical Manual

Page: 37 / 125

Copyright by Servizio Clienti ANGELO PO Spa
37
d) Press “cooldown” and turn the knob to enable / disable the cooldown with water
injection during cooking.
- Wait without pressing any button for to come back to normal mode.
Update parameters procedure (alignment of the power board with the CPU) - only
boards 2
nd
generation (after March 2014)
After a replacement of the CPU or power board the alignment of the boards has to be
done.
1) With the oven on in standby mode, push for at least 4 seconds the "reset" button, when
it is released the display turns off.
2) Press the "vacuum probe" button in order to start the procedure ( “-“ will run on the lower
display). During the upgrade no key is active. The update will start only if there is no E13
alarm (communication failure).
3) After the update the display turns off again.
SW update - only boards 2
nd
generation (after March 2014)
The SW update from USB stick has to be done as following:
1) With the oven on in standby mode, push for at least 4 seconds the "reset" button, when
it is released the display turns off.
2) Press the "steam injection button" to enter into the SW update from USB , the first
screen displays " USb " flashing. To leave the procedure just press again "steam injection
button". If during " USb " flashing you insert a USB stick and the board recognizes it , the
flashing stops and the message " USb " is steady and also turns on the START / STOP
button in green color. The stick (recommended max. size 4GB) must be formatted FAT
or FAT32 and contain a directory "AngeloPo_L1_L2" with all the necessary files
inside). .