Angelo Po FX Series, Technical Manual

Page: 121 / 125

Copyright by Servizio Clienti ANGELO PO Spa
121
Alarm on
display
Problem (on
the manual)
Solution (on the
manual)
Note (on the
manual)
Note for Service
OPE
Oven door
opening or
closure request.
Open or close the oven
door. Inform the after-
sales service if this
message continues to be
displayed.
The cooking
cycle does not
start until the
door has been
opened or
closed as
required.
Check the door magnetic micro switch,
to be correctly connected to the power
PCB by wires 42 and 43. It could be
interruption or short circuit.
CLE
W01
W02
Cleaning alarm --- ---
See chapter 5.6
(cleaning warnings)
E01:CC
The cooking
chamber probe
has failed or is
not properly
connected.
(Short circuit)
Inform the after-sales
service.
The oven’s
functions are
disabled so no
cooking
cycles can be
carried out.
Check the chamber probe. The
resistance value must be about 1100
Ohm at 25°C. The probe is connected
to the terminals 44 and 45 of the power
PCB.
E01:--
The cooking
chamber probe
has failed or is
not properly
connected.
(Circuit open)
Inform the after-sales
service.
The oven’s
functions are
disabled so no
cooking
cycles can be
carried out.
Check the chamber probe. The
resistance value must be about 1100
Ohm at 25°C. The probe is connected
to the terminals 44 and 45 of the power
PCB.
E02:CC
The product
core probe has
failed.
(Short circuit)
Check the position of the
product core probe or
inform the after-sales
service if it is faulty.
Cooking
cycles with
product core
probe cannot
be carried out.
Check the core probe. The resistance
value must be about 1100 Ohm at
25°C. On the ovens level 2, the probe
is connected to the terminals 46 and 47
of the power PCB. On the ovens level
3, the multipoint core wires are
connected to terminals 74-75-76-77-78
(wires red-yellow-blue-green-black) of
the expansion PCB, and the white one
is connected to terminal 73.