Angelo Po FX Series, Technical Manual

Page: 24 / 125

Copyright by Servizio Clienti ANGELO PO Spa
24
- Wait until the end of the procedure and check the list of devices in comparison with
the table below.
- If you get the alarm E20 during the procedure, reset with the reset button and repeat
the procedure by pressing the function "repeat configuration ”. If the problem
persists, then switch off the oven, wait 30 seconds and then switch it on.
- NOTE: When You change inverter and/or gas blower control, E20 will always
appear during configuration process and a switch-off / switch-on procedure it’s
always required before repeat configuration.
- Verify the items found and control the wiring of the components not detected.
- If at the end of the procedure, the screen does not match the table below, check the
wiring and repeat the configuration by pressing "repeat configuration”.
- If the configuration is correct (the screen corresponds to the table) press "OK".
Alarm log: Selecting this voice you get the list of the last thirty alarms that have occurred
on the oven. The list will show you the alarm code, date and time.
Temperature: Allows you to configure the temperature unit used in the normal operation of
the oven. The choices can be °C or °F. To change the setting, put the cursor on the line
"Temperature" and select the new unit pushing the knob.